機能と設備
Whether in manual pouring operation or integrated in an automated casting cell, the electrically heated bale-out furnaces are characterized by very good melt quality, optimum energy efficiency and low-maintenance operation. These furnaces are available with reduced connected load for only holding of aluminum alloys or with increased power for holding and melting as allrounders.
- T ../10 for holding aluminum alloys
- T ../11 for melting and holding aluminum and zinc alloys
- T ../13 for melting and holding copper alloys such as bronze or brass
- Free radiating heating elements arranged on four sides on support tubes provide for long service life and easy replacement
- Twelve months warranty on heating elements
- High melting performance with temperature uniformity in the melt
- Multi-layer insulation for optimum energy efficiency and low external wall temperatures
- Exclusive use of insulation materials without categorization according to EC Regulation No 1272/2008 (CLP). This explicitly means that alumino silicate wool, also known as “refractory ceramic fiber” (RCF), which is classified and possibly carcinogenic, is not used.
- Emergency outlet for safe draining of the melt in case of crucible breakage
- No exhaust gas discharge needed
- Integrated safety system which continues to operate the furnace at reduced power in case of malfunction in the thermocouple, in order to prevent the freezing of the melt
- Over-temperature limiter in furnace chamber for protection against overheating. The limiter switches the heating off when the set limit temperature is reached, and only switches it back on after the temperature has fallen again.
- Low-maintenance furnace chamber control with temperature measurement behind the crucible
- Defined application within the constraints of the operating instructions
その他の製品
