Высокотемпературные печи со стержневым карбидкремниевым нагревателем и волокнистой изоляцией до 1550 °C
Обогрев с двух сторон с помощью стержневых нагревателей с вертикальной подвеской.
Функции и оборудование
The high-temperature furnaces HTC 16/16 - HTC 450/16 are heated by vertically hung SiC rods, which makes them especially suitable for sintering processes up to a maximum operating temperature of 1500 °C. For some processes, e. g. for sintering zirconium oxide, the reduction of interactivity between the charge and the SiC rods, these models are more suitable than the alternatives heated with molybdenum disilicide elements. The basic construction of these furnaces make them comparable with the already familiar models in the HT product line and they can be upgraded with the same additional equipment.
- Tmax 1550 °C
- Recommended maximum working temperature approx. 50 °C below Tmax of the furnace. Higher working temperatures will increase wear and tear.
- Dual shell ventilated housing made of textured stainless steel sheets for low surface temperature and high stability
- Heating from both sides via vertically mounted SiC rods
- High-quality fiber insulation backed by special insulation
- Long-life roof insulation with special suspension
- Exclusive use of insulation materials without categorization according to EC Regulation No 1272/2008 (CLP). This explicitly means that alumino silicate wool, also known as “refractory ceramic fiber” (RCF), which is classified and possibly carcinogenic, is not used.
- Temperature uniformity at 1450 °C up to +/− 10 °C according to DIN 17052-1
- Chain-guided parallel swivel door for defined opening and closing of the door without destroying the insulation
- Two-door design (front/back) for high-temperature furnaces > HTC 276/..
- Labyrinth sealing ensures the least possible temperature loss in the door area
- Reinforced floor as protection for fiber insulation and to load heavy weights
- Vapor vent in the furnace roof with motorized exhaust air flaps
- Stainless steel exhaust hood as interface to customer’s exhaust system
- Defined application within the constraints of the operating instructions
- NTLog Basic for Nabertherm controller: recording of process data with USB-flash drive
- Controller with touch operation P570 (50 programs with each 40 segments)
Другие продукты
каталог
Полный обзор нашего обширного ассортимента — от малых лабораторных печей до комбинированной печной установки для депарафинизации и спекания в одном процессе — вы найдете в нашем каталоге «Продвинутые материалы».